Emos P5821 - Display Settings and Time Modes; Current Time Setup Procedure; Switching Between 12;24 Hour Formats; Viewing Usage Data

10
Display settings:
1. current time setup
1.1 Press and hold the „SET/OK“ button for 3 seconds. You
will enter the settings mode and the clock icon will start
blinking.You can change the time values using the buttons
„ENERGY/+“ (increasing values) or „COST/-“ (decreasing
values). Pressing the „HISTORY“ button will switch between
hours and minutes. Once current time is set, press „SET/OK“.
Switching to 12/24 hour mode
After setting the current time, the metre will work on a24 hour time cycle. If you want to
switch to 12 hour mode, simultaneously hold the „HISTORY“ and „ENERGY/+“ buttons for
3 seconds. The display will show the AM or PM symbol. AM indicates morning hours, PM
afternoon hours. Set the desired time mode (12/24).
1.2 Total operating time of the connected appliance (TOTAL TIME):
Once the load (input power of the connected appliance) exceeds 2 W, total time will start
recording automatically. You can display the total operating time by pressing the „COST/-“
button.
1.3 using the „COST/-“ button, the display will show the following, in order:
• Total operating time
• Total power consumption 0.00–9 999 kWh
• Total power costs 0.00–9 999 EUR