Emos P5821 - CO₂ Monitoring and Consumption Graphs; Setting CO₂ Measurement Parameters; Understanding Consumption Graphs (7 Days;Weeks;Months)

13
4. Setting CO :
Keep pressing „COST/-“ until you reach the following screen.
Then hold the „SET/OK“ button for 3 seconds. Using the „HISTORY“ button, move between
values. „ENERGY/+“ and „COST/-“ increase/decrease the values. You can save the settings
by pressing „SET/OK“.
5. Consumption graph for the last 7 days/weeks/months
Using the „HISTORY“ button, you can change display settings to the last 7 days, 7 weeks or7months.
7 days
the top right corner of the graph shows the conversion ratio, indicating the power consumed. In this
case, each bar corresponds to 1 kWh, i.e. yesterday, power consumption was 2 kWh (1 kWh × 2 bars)
7 weeks
the top right corner of the graph shows the conversion ratio, indicating the power consumed.
In this case, each bar corresponds to 20 kWh (2 kWh × 10), i.e. last week, power consumption
was 60 kWh (20 kWh × 3 bars)
7 months
the top right corner of the graph shows the conversion ratio, indicating the power consumed.
In this case, each bar corresponds to 50 kWh (5 kWh × 10), i.e. last month, power consumption
was 100 kWh (50 kWh × 2 bars)