Emotron AB 01-3991-11r2 Programming instructions and menu list 47
Remote/Local change function
Local mode
Run command via the key on the keypad
Frequency command
When [215]=000: only the or key on the keypad can control and
[212] setting has no effect.
When [215]=001: only VR on the keypad can control and [212] setting has
no effect.
Remote mode
Run command from Run menu [213] control setting
Frequency command from Frequency menu [212] control setting
Remote/Local change mode on keypad is achieved by simultaneously pressing
and . Each successive operation toggles between local and remote.
The display
Menu levels
The display has one row with space for three characters. Menu level is indicated
by flashing of the corresponding character. This means:
• When you are in the first level (hundreds), the left most character is flashing.
• When you are in the second level (tens), the middle character is flashing.
• When you are in the third level (units), the right most character is flashing.
Enter data
• Press the key to enter the editing mode.
• Use the or key to enter data.
• Confirm value by pressing the key.
Note: The VSD must be stopped.
To Next Page
Loading...
Need help?
General
