Need help?Do you have a question about the EMPHASER EA4160S and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 10 Hz - 30 kHz |
| Damping factor @ 4 ohms | >200 |
| Input sensitivity | 0.2 - 6 V |
| Highpass filter | 50 Hz - 500 Hz |
| Lowpass filter | 50 Hz - 500 Hz |
| Weight | 3.5 kg |
| Power Output (Max) | 4 x 160 W |
| RMS power @ 4 ohms | 4 x 100 W |
| RMS power bridged @ 4 ohms | 2 x 320 Watts |
| THD @ 4 ohms | <0.05% |
| Bass boost | 0 - 12 dB @ 45 Hz |
| THD | 0.05% |
| Power Output (RMS) | 4 x 100 Watts @ 4 Ohms or 2 x 320 Watts @ 4 Ohms bridged |
| Power Output | 4 x 160 Watts @ 4 Ohms max. / 4 x 100 Watts @ 4 Ohms RMS 4 x 190 Watts @ 2 Ohms max. / 4 x 120 Watts @ 2 Ohms RMS 2 x 500 Watts @ 4 Ohms bridged max. / 2 x 320 Watts @ 4 Ohms bridged RMS |
Features selectable highpass/bandpass filtering with 12/24 dB/octave crossover slopes.
Safeguards amplifier from short-circuits, DC offset voltage, and overheating for reliability.
Instructions for routing positive and ground main power cables, including essential fuse placement for safety.
Guide to setting the high-pass crossover frequency for satellite speaker systems, typically 50-150Hz.
Instructions for adjusting the low-pass crossover frequency, including subsonic filter setup (60-90Hz recommended).
Procedure for correctly setting input gain (GAIN controls) for optimal dynamic response and tonal balance.
To Next Page
