Need help?Do you have a question about the EMPHASER EA2260S and is the answer not in the manual?
General| Channel Configuration | 2-channel |
|---|---|
| Amplifier Class | Class AB |
| RMS Power @ 4 ohms | 60W x 2 |
| Frequency Response | 10Hz - 30kHz |
| THD @ 4 ohms | < 0.05% |
| Signal to Noise Ratio | > 100dB |
| Input Impedance | 10k ohms |
| Bass Boost | 0 - 12dB @ 45Hz |
| Power Supply | 12V DC |
| Lowpass Filter | 50 Hz - 250 Hz |
Details on front panel connectors and controls for EA2160s/EA2260s models.
Details on rear panel connectors and power input terminals for EA2160s/EA2260s.
Details on front panel connectors and controls for the EA4160s model.
Details on rear panel connectors and power input terminals for the EA4160s model.
Recommended speaker impedance ratings and main power wire gauge recommendations.
Guidance on routing positive and negative main power cables, including fuse placement.
Instructions for routing audio signal and remote turn-on/off wires separately from power cables.
Steps for connecting speaker wires, ensuring correct polarity and secure connections.
How to set the operation mode (Highpass, Bandpass) based on speaker system configuration.
Adjusting the high-pass filter frequency for satellite speakers, with recommended ranges.
Adjusting the low-pass filter frequency for subwoofers, with sonic tuning advice.
Adjusting the subsonic high-pass frequency for bandpass subwoofer operation.
Setting input gain controls correctly for optimal dynamic response and tonal balance.
Details on damages not covered by the warranty, including installation and misuse.
To Next Page
