Empi EPIX VT - Page 16

10
User Information
Program Options continued
5 Ramped Burst (RB)
wH inkes
Thrhri
The Ramped Burst program gradually increases the intensity from 0
to the set level over 0.4 second, maintains it at the set level for 1.0
second, and then gradually decreases the intensity over 0.5 second.
The device then sends no stimulation for 3.0 seconds. The rate is set
at 100 pps. The pulses are delivered through both channels
simultaneously.
6 Alternating Ramped Burst (ARB)
LL
The Alternating Ramped Burst program is the same as the Ramped
Burst, but Channel 2 starts after Channel 1 has completed a cycle.
Channel 1 gradually increases intensity from 0 to the set level over
0.5 second, holds at the set intensity for 5.0 seconds, and then
decreases intensity over 0.5 second. Channel 1 then stays off for 6.0
seconds. As Channel 1 intensity is decreasing, Channel 2 starts
increasing intensity, via the same pattern. The set rate is 100 pps.
7 Modulated Amplitude (MA)
100 pps
i adaddgagaaaanneaae
In the Modulated Amplitude program, for 0.5 second the intensity
is at 100% of the set level and the next 0.5 second, it is at 60%.
The cycle is then repeated. There is no off time. The rate is 100
pps. Both channels are used simultaneously.
8 Random Modulation (RM)
Rate is selected pseudo-randomly from 8 rates - 2, 10, 20, 40, 60,
80, 100, 150 pps; pulse duration is selected pseudo-randomly from
7 values between 50% of set pulse duration and set pulse duration.
Each combination is on for 1 second.