To Next PageTo Next Page
Need help?Do you have a question about the Empire Comfort Systems DVCD32FP30N-1 and is the answer not in the manual?
General| Model Number | DVCD32FP30N-1 |
|---|---|
| Category | Indoor Fireplace |
| Fuel Type | Natural Gas |
| BTU Input | 30, 000 BTU |
| Ignition System | Electronic |
| Ignition Type | Intermittent Pilot |
| Vent Type | Direct Vent |
| Log Material | Ceramic Fiber |
| Blower Included | Yes |
| Thermostat Compatible | Yes |
| BTU | 30000 |
| Glass Type | Tempered |
Product identification and basic overview of the direct vent gas fireplace heater.
Critical safety warnings regarding hot glass, flammable materials, and gas leaks.
Precautions regarding the tempered glass front panel, including replacement procedures.
Immediate actions to take if an LP gas leak is detected.
Information on LP gas odor detection, fade, and sensitivity issues.
Key technical data including BTU, orifice sizes, and dimensions.
Table detailing minimum clearances to combustible materials.
Procedure for checking manifold gas pressures for Natural Gas and LP.
Instructions for framing the fireplace and finishing the installation.
Minimum clearances required around vertical and horizontal vent pipes.
Guidance on planning vent runs for proper installation and performance.
Instructions on how to use the graph for determining permissible vent runs.
Diagrams illustrating clearances for various termination locations.
Detailed definitions for various vent clearance measurements.
How to operate the standing pilot 750 millivolt system.
Step-by-step guide for lighting the fireplace for the first time.
Instructions for operating the REMOTE/OFF/ON switch and wall switches.
Diagram illustrating wiring connections for standing pilot systems.
Procedure for safely shutting off the gas supply to the fireplace.
Diagnosing and resolving issues with pilot ignition.
Troubleshooting steps when the pilot flame does not remain lit.
Diagram showing wiring for direct ignition systems, including LED codes.
Steps for safely lighting the direct ignition fireplace.
Procedure for safely shutting off the gas supply.
Steps for purging air from the gas lines before initial ignition.
Diagnosing issues when no spark or ignition occurs.
Information on conversion requirements and safety warnings.
Detailed steps for converting the gas valve and components.
Routine maintenance for the fireplace and venting system.
Instructions for safely removing and replacing the glass front.
