How to fix skipped stitches on my Empisal Overlock machine?
If your Empisal Overlock machine is skipping stitches, consider the following solutions: 1. Replace bent, blunt, or damaged needles with new ones. 2. Ensure needles are correctly inserted into the needle clamp. 3. Verify that the machine is threaded correctly. 4. Use the correct type of needles (HA×1 or 130/705H).
What to do if needles break on Empisal Overlock machine?
If the needles are breaking on your Empisal Overlock machine, it could be due to: * Damaged needles: Bent, blunt, or damaged needle points. Replace them with new needles. * Incorrect insertion: Needles not inserted correctly. Insert the needles correctly into the needle clamp. * Forcibly pulling fabric: Guide the fabric gently with both hands instead of pulling it.
Why are the stitches irregular on my Empisal Overlock machine?
Irregular stitches on your Empisal Overlock machine can occur if: * The thread tension is incorrect. Correct the thread tension. * The thread is caught. Check the threading path of each thread.
How to prevent seam puckering on my Empisal Overlock machine?
Seam puckering on your Empisal Overlock machine can be caused by: * Excessive thread tension: Correct the thread tension. * Incorrect threading: Thread the machine correctly. * Thread being caught: Check the threading path of each thread. * Incorrect differential feed setting: Set the differential feed to “S.”
What to do if fabric edges curl when using my Empisal Overlock machine?
If the fabric edges are curling when using your Empisal Overlock machine, it might be because too much fabric is within the stitch. Try re-adjusting the seam width.
Why does the thread keep breaking on my Empisal Overlock machine?
The thread might be breaking on your Empisal Overlock machine due to several reasons: * Incorrect threading: Make sure you thread the machine correctly. * Excessive thread tension: Reset the thread tension. * Improper needle insertion: Ensure the needles are correctly inserted into the needle clamp.
Why is my Empisal Overlock machine not cutting fabric neatly?
If your Empisal Overlock machine isn't cutting fabric neatly, it could be because the upper cutter is blunt or wrongly positioned. Replace or adjust the cutter.
Essential safety precautions for operating the overlock machine.
Preliminary steps to ensure proper machine setup and initial use.
Steps for connecting the foot control to the machine and power.
Guidance on setting correct tensions for needle threads.
Guidance on setting correct tensions for looper threads.
How to adjust the differential feed for various fabric types.
General| Brand | Empisal |
|---|---|
| Model | S4D |
| Category | Sewing Machine |
| Language | English |
To Next Page
