with groove in the appliance, then insert the funnel into the appliance from the “ ” position, and
fix them into coffee maker firmly by turning it anticlockwise until it is at the “
” position.
3. Place an jug on removable cup shelf. Make sure steam control knob is on the OFF position.
4. Connect into power source, press power button, power indicator flashes, the machine begins
preheating, after power indicator is solidly on, the preheating is completed
5. Press 2-cup coffee button, the unit will pump water for about 25s, pour out water in the cup then
clean them thoroughly, now the appliance is ready for making coffee.
1. Remove detachable water tank and open water tank cover to fill it with desired water, the
Note: There may be noise when pumping water for the first time,
it is normal that the appliance is
releasing the air inside. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee,
we recommend you should preheat the appliance before
making coffee, including metal funnel,
steel mesh and cup, so that the coffee flavour can not be
influenced by cold parts.
water
level should not exceed the “MAX” mark in the tank. Then replace water tank
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into th
e appliance from the “
” position, and fix them into
coffee maker firmly by turning it anticlockwise until it is at the “
” position.
3. Place an espresso cup on removable cup shelf.
4. Then connect appliance to power supply. Make sure steam control knob is on the OFF position.
5. Press power button, power indicator flashes, the machine begins preheating, after power indicator
is solidly on, it means that preheating is completed, press 2-cup coffee button, the machine pumps
water, when there is water flowing out, press this coffee button again to stop pumping water
immediately. The purpose of this step is to pump the water of water tank into boiler.
6.
When power indicator is solidly on, it indicates the preheating is finished
MAKE ESPRESSO
1. Remove funnel by turning it clockwise. Add ground coffee into steel mesh with measuring spoon,
a spoon of ground coffee powder can make about a cup of top-grade coffee, then press ground
coffee powder tightly with the tamper.
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the “
” position, and fix them into
coffee maker firmly by turning it anticlockwise until it is at the “
” position.
3. Place a cup on removable cup shelf.
4. After preheating is completed, press 1-cup or 2-cup coffee button, the product will start brewing,
working time for 1-cup coffee is 15 seconds and 25 seconds for 2-cup coffee .
5. At the time corresponding coffee button indicator is to be illuminated, when the time up ，
To Next Page
Loading...