Introduction
The Interferential 960 provides Interferential 4-pole and two independent
channels of 2-pole and/or Medi-Wave electrotherapy only.
The Multidyne 970 provides two independent electrical stimulation
channels each with a complete range of low and medium frequency
waveforms (including Interferential) for electrotherapy and electro-
diagnostics. The units may be powered from a (specific) desktop mains to
DC PSU or from a suitable external DC power bank.
Indications for use
Voltage and current waveforms may be used to provide Neuro Muscular
Electrical Stimulation (NMES) and relief from musculoskeletal pain.
NMES may be used for muscle strengthening and rehabilitation in
otherwise healthy subjects recovering from surgery, for muscle
strengthening for critically or chronically ill patients or to (re)train weak or
ineffective muscles.
Pain relief may be appropriate post-surgery during rehabilitation, or for
relief from chronic conditions such as osteoarthritis.
The various output waveforms available from the units are suitable for
either NMES and/or pain relief as shown in the chart in Appendix D on
page 61.
Precautions
Therapy shall be performed by qualified personnel trained and/or
experienced in the use of this device as outlined in an appropriate training
program.
Electromagnetic interference: This device may cause electromagnetic
interference to electronic devices
The emissions characteristics of this device make it suitable for use in
industrial areas and hospitals (CISPR 11 class A). If it is used in a
residential environment (for which CISPR 11 class B is normally required)
this device might not offer adequate protection to radio-frequency
communication services. The user might need to take mitigation measures,
such as relocating or re-orienting the equipment.
To Next Page
Loading...
