Adjusting Fade In for the Color
Channels
Manual
Fade 8.5S
Fig. 7.6 Adjusting a fade in time
It is possible to adjust a fade in time for
illumination scenes affecting the RGBW color
channels 1-4 and the dimmer channel. When
actuating a sliding control, the corresponding
channel is moved slowly and steadily
to its target value. The controller automatically
creates all necessary intermediate values.
Keep the button
FIXTURE
pressed and
simultaneously adjust the fade in time with the
pan wheel
between 0-30 seconds. When turning
the wheel, the display indicates the selected value
in the lower line, e.g. “Fade 8.5S“ for a fade in
lasting 8.5 seconds.
Deleting Illumination Scenes
Program
Fig. 7.7 Programming mode
1
Call the programming mode. For this, keep
the
REC
pressed until the LED above the
button lights.
2
Press the button
SCENE
.
•
The control LED lights.
3
Keep the button
DEL
pressed and select the
scene to be deleted with the
number
buttons 1-16
.
•
The control LEDs of the memory banks
containing data light.
•
If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights).
•
To confirm the deleting procedure, all LEDs
of the controller flash three times.
4
After the desired scene has been deleted,
switch off the programming mode. For this,
keep
the button
REC
pressed until the LED
above the
button lights.
To Next Page
Loading...