the control elements. The display indicates
the control element in the upper line, e.g.
“Fader CHANL:1/R “ and the DMX channel in
the lower line, e.g. “DMX channel:01”
Fader CHANL:1/R
4
Select the option
FADER REVERSE
with the
button
SWAP
. The display indicates the
control element in the upper line, e.g.
“FADER:1/R “ and the current setting in the
lower line, e.g. “REVERSE:NO“.
DMX channel:01
FADER:1/R
REVERSE:YES
Fig. 6.2 Channel assignment
5
Adjust the first control element with the
pan
wheel
, e.g. 1/R = sliding control 1 and
assign the
DMX channel with the
tilt wheel
.
Tab. 6.2 Assignment of DMX channels to the control elements
6
Press the button
ENTER
to memorize your
setting.
•
To confirm the memory procedure, all LEDs
of the controller flash three times.
7
Repeat the steps 5 and 6 to assign further
DMX channels.
8
Press the button
DEL
to delete an
assignment (indication „NULL“).
•
To confirm the deleting procedure, all LEDs
of the controller flash three times.
9
After your settings, exit the system settings.
For this, keep the button
MENU
pressed for
2 seconds.
Inverting Output Values
It is possible to individually invert the output
values of the 512 control channels. The
adjustment can be made in the system settings.
1
Keep the button
MENU
pressed for 2
seconds to call the system settings.
2
The display indicates the first menu item
„01.Patch fixture“ (otherwise select it with the
pan wheel). Press the button
ENTER
to
begin with the configuration. The display
indicates “PLEASE SELECT FIXTURE”.
3
Use the
number buttons 1-16
to select the
unit
of which the DMX channels are to be
inverted
(control LED lights).
Fig. 6.3 Inverting output values
5
Adjust the first control element with the
pan
wheel
and use the
tilt wheel
to select the
setting [
YES
] if
the output value of the control
channel is to be
inverted or [
NO
] if not. With
activated inversion the
output value is zero if
the control channel has
been set to the
maximum value and vice versa.
6
Press the button
ENTER
to memorize your
setting.
•
To confirm the memory procedure, all LEDs
of the controller flash three times.
7
Repeat the steps 5 and 6 to invert further
control channels.
8
Repeat the steps 3, 5 and 6 to adjust further
units.
9
After your settings, exit the system settings.
For this, keep the button
MENU
pressed for
2 seconds.
Assigning the Fade In Function
The fade in function for the RGBW color channels
1-4 and the dimmer channel can be individually
assigned to each device. The adjustment can be
made in the system settings.
1
Keep the button
MENU
pressed for 2
seconds to call the system settings.
2
The display indicates the first menu item
„01.Patch fixture“ (otherwise select it with the
pan wheel). Press the button
ENTER
to
begin with the configuration. The display
indicates “PLEASE SELECT FIXTURE”.
3
Use the buttons
number buttons 1-16
to
select
the unit to be configured (control LED
lights).
4
Select the option
COLOR FADE
with the
button
SWAP
.
COLOR FADE
FIXTURE:01 [NO]
Fig. 6.4 Assigning the fade in function
To Next Page
Loading...