Overwriting Channels Manually
During the playback of a chase, it is possible to
overwrite the programmed DMX values with the
sliding controls. This allows for minor adjustments
during a live performance without the need for
reprogramming scenes.
1
Press the button
FIXTURE
use the
number
buttons 1-16
to select the units to be
controlled
manually.
2
Adjust the desired DMX values for the DMX
channels using the
sliding controls
and, if
necessary, the
pan and tilt wheels
.
3
If necessary, use the button
PAGE
to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights) and repeat
steps 1 and 2, until the desired values are
assigned to all channels.
Blackout Function
With the blackout function it is possible to blackout
and illumination scene or chase completely.
Current fadings and chases are not stopped by
the blackout function, they continue “in the dark”
in the meantime.
1
With the button
BLACK OUT/DEL
this
function
is switched on: The LED above the
button
flashes and all control channels are
set to the
output value zero.
2
By pressing the button
BLACK OUT/DEL
again, the function stops: The LED is
extinguished and all channels return to their
pervious output values.
3
In the system settings, is possible define
whether all control channels react to the
button
BLACK OUT/DEL
or only the dimmer
control channel.
Deleting a Chase
Program
After Use
After the operation, disconnect the mains plug of
the power supply unit from the socket, to prevent
unnecessary power consumption.
Fig. 7.16 Programming mode
1
Call the programming mode. For this, keep
the
REC
pressed until the LED above the
button lights.
2
Press the button
CHASE
.
•
The control LED lights.
3
Keep the button
DEL
pressed and select the
chase to be deleted with the
number
buttons 1-16
.
•
The control LEDs of the memory banks
containing data light.
•
If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights).
•
To confirm the deleting procedure, all LEDs
of the controller flash three time.
4
After the desired chase has been deleted,
switch off the programming mode. For this,
keep
the button
REC
pressed until the LED
above the
button lights.
To Next Page
Loading...