EMSI EMS-5000 - Indicators and Controls; Preparation for Use; Check Battery; Prepare Skin for Electrode Placement

INDICATORS AND CONTROLS
Channel 1
Output Indicator Light
Channel 1
Output Receptacle
Channel 1 On/Off and
Amplitude Control
Channel 2 On/Off and
Amplitude Control
Channel 2
Output Indicator Light
Channel 2
Output Receptacle
Power indicator Light
Contraction
Control
CONTRACTION FREQUENCY(Hz) RELAXATION
TIME (S) 5 30 100 TIME (S)
J~^ nun /^~\__
1 30 RAMP(S) ! 45
9V — 6F22 |
3
Relaxation Control
PREPARATION FOR USE
1. Check Battery. Insure that you are using a fresh battery.
2. Prepare Skin. Before applying electrodes, be sure to confirm
correct electrode placement as recommended by your physician
or therapist. Each location should be washed, rinsed and
thoroughly dried.
3. Prepare Electrodes. Apply gel in a thin even layer (about the
thickness of a match book cover) to the bottom of the elec-
trode. Avoid using too much gel.
Note : If you are using reusable electrode,
please disregard the procedure.