Need help?Do you have a question about the EMSI EMS-5000 and is the answer not in the manual?
General| Type | Electrical Muscle Stimulator |
|---|---|
| Model | EMS-5000 |
| Category | Medical Equipment |
| Intensity Levels | Adjustable |
| Portability | Portable |
| Modes | Multiple pre-set programs and manual mode |
| Application | Pain relief, muscle rehabilitation |
Insert the pin connector into the electrode, holding the connector for protection.
Ensure amplitude controls for both channels are turned to the "OFF" position before use.
Insert the receptacle end of the lead wire into the appropriate channel output receptacle.
Turn the Contraction and Relaxation controls to the settings recommended by your medical professional.
Set Frequency to 5, 30, or 100 Hz and Ramp to 1, 3, or 5 seconds as advised.
Check battery and control settings if power light is dim or unit is non-functional.
Verify electrode position, lead wire connections, and replace battery if indicators are off.
If problems persist after troubleshooting, contact your supplier for servicing.
To Next Page
