Emtec P600 User Manual

4
1. Overview
1. Battery level LED
Red: Low battery
Flashing Green: Charging
Solid Green: Drive On
Off: Battery full or Drive Off
2. HDD read/write LED
White: Stand-by
Flashing White: Read/Write
(LED is blue when the device is connected at
a USB3.0 port)
3. Wi-Fi LED
Blue: Wi-Fi ready
4. Internet LED
Green: connected to Internet
5. Power Button
Press and hold for 2 seconds to power
on/turn off the device.
On: Wi-Fi HDD mode.
Off: Synchronization mode (The HDD works
as a standard portable HDD).
6. USB 3.0 Port
7. Reset
8. Ethernet port (RJ45)
2. Install and Set Up
2.1. Download Emtec Connect App
Download “Emtec Connect” application on the App Store.
2.2. Connect your Wi-Fi HDD to your iPhone/iPad (no Internet connection required)
1. Turn-on your Wi-Fi HDD P600. Once the Wi-Fi blue LED stops flashing, the Wi-Fi function is ready.
2. Go to Wi-Fi settings on your iPhone/iPad and activate your Wi-Fi connection. Then choose the
name of your Wi-Fi HDD in the network list.

Emtec P600 Specifications

General

Brand	Emtec
Model	P600
Category	Storage
Language	English