WEL-200™ Operating Instructions 11
Document no. 10320104 Revision 2.0 3-1-19
2.7.1. Without activating the edge, observe the channel status LED, it should be OFF.
2.7.2. When the edge is activated, the receiver channel status LED will turn on and
the corresponding OPEN/CLOSE direction output will activate. The transmitter
status LED will blink once every second when the edge is activated.
2.7.3. If the channel does not exhibit this behavior, double check the edge
wiring/termination and transmitter batteries.
Notes
1. If channel 1 and 4 switches are pressed simultaneously during power up, the receiver will
perform a factory reset and clear all programmed channels.
2. Channel assignment mode will exit under the following conditions:
a. Successful connection to a transmitter
b. 60 second timeout
c. User selected exit
i. Pressing channel 1 and 4 switches simultaneously for more than 2 seconds
3. To remove a connection from the transmitter, hold down the connection button. The
LED will turn on solid for several seconds, and then blink twice every 2 seconds when
disconnected.
To Next Page
Loading...
Need help?
General