Enco Control - Page 11

ENCO Control
Technical description
•Kulautuvos g. 45a , LT-47190 Kaunas •Tel. (+370 37) 360234 •Faks. (+370 37) 360358 •info@axis.lt • www.axis.lt
11
2.7. Reboot
1. Off
2. On
Restart the device if there is no communication with the outside server for a specified period of
time:
DHWReboot per.
Yes No
1440
communication channel (port) for configuration of device via network.
Using this port, it is possible to find the device's on the local network, without knowing its IP
address:
DHWUDP hello
Yes No
37770
3. settings for reading external devices (meters):
3. Modules
1. Module - - -
2. Module - - -
3. Module - - -
4. Module - - -
5. Module - - -
6. Module - - -
7. Enable connect On
8. Connect. type Ethr
9. Connect prt 37777
10.Remote enable Off
11.IP 192.168.0.211
12.Remote port 37775
13.Connect per. 3600
Select the required device type:
3.1. Module
1. Type - - -
3.1.1. Module
1. - - -
2. SKS-3
3. SKM-1-M
4. SKM-01M
5. SKU01
6. SKU01SF
7. SKU01M
8. M-BUS
9. HEAT SYS
10.MODBUS R
11.MODBUS
12.SR-1K
3.1. Module
1. Type SKS-3
2. State On
3. Ext. port Off
4. Interf. Mbus[0]
5. Baud rate 9600
6. Parity Even
7. Array 0
8. Addr|ID 254
9. Period 3600
10.Module date
Select type of communication interface: