Enco Control - Page 14

ENCO Control
Technical description
•Kulautuvos g. 45a , LT-47190 Kaunas •Tel. (+370 37) 360234 •Faks. (+370 37) 360358 •info@axis.lt • www.axis.lt
14
4. LAN state
Review of LAN communication parameters
Address GPRS:
7.3. GPRS state
1. IP 82.15.131.228
2. MK 255.255.255.0
3. DNS1 213.226.131.1
4. DNS1 193.219.88.36
Address LAN:
7.4. LAN state
1. IP 192.168.2.100
2. GW 192.168.2.254
3. MK 255.255.255.0
4. DNS1 212.59.1.1
5. DNS1 192.168.2.254
set up date and time manually.
8. Set date & time
1. Date 2012-01-21
2. Time 09:25:19
3. Week day 3
Device performs:
 Monitoring of all recorded data or registering selected data or variables
 Selecting of the frequency (period) archiving (from 1s)
 Archiving of parameters technological process and variables in the heating system
every 5 minutes to 7 days
 Sending of message, if parameter value exceeds the limits (up to 32 selected
parameters).
The controller can read all meters that support MBUS protocol. Reading is performed Wild
card search algorithm. The data from the meters can be read out to the primary or secondary
addresses. There is a possibility to read out only one meter, without using
algorithm. Meter reading data is decoded and selected parameters are saved to the archive
(only those parameters are saved in the archive that are selected by the user). Meter reading
frequency is freely selectable.
The device can communicate via Ethernet, GSM / GPRS. It supports protocols TCP / IP, UDP,
DHCP.