Enco Control - Page 13

ENCO Control
Technical description
•Kulautuvos g. 45a , LT-47190 Kaunas •Tel. (+370 37) 360234 •Faks. (+370 37) 360358 •info@axis.lt • www.axis.lt
13
clear channel communications for reading of data of externally devices via
the Internet, using specialized programs. The settings are analogous to modem settings:
4. Receivers
1. UART0
2. UART2
4.1. Port settings
1. Interf. Off
2. Baud rate 9600
3. Parity None
4. Bits 8
5. Stopbits 1
temperature sensors status:
5. Temper. sensors
1. Reinit sensors
2. Sensors count 3
3. T[01] 49.95°C
4. T[02] 38.87°C
5. T[03] 15.01°C
Field
Description
1. Reint sensors
New search of all connected sensors
2. Sensors count
Shows the number of sensors that have been found
3. T[xx]
Shows temperature value of corresponding sensor. It is possible to
change the sensor number
review and control of inputs / outputs status
6. Outputs/Inputs
1. Output0
2. Output1
3. Output2
4. Output3
5. Output4
6. Output5
7. Output6
8. Output7
9. Output8
10. Input0
11. Input1
12. Input2
13. Input3
14. Input4
15. Input5
16. Input6
The black dot inside the circle means that the input / output are active /actuated. An empty
circle (white circle) indicates that the input / output are not active / disabled.
status of communication channel
7. Connection state
1. Modem connected
2. Signal quality 19
3. GPRS state
4. LAN state
Field
Description
1. Modem
Modem status indicates whether the device is connected to the GPRS
2. Signal quality
Level of GSM signal
3. GPRS state
Review of GPRS communication parameters