ENDA ETC 4420 User Manual

AL1
CNT/AL2
SSR
TEMPERATURE CONTROLLER
ETC 9420
ENDA
PV
SV
SET
ASETCSET
ETC 8420
PV
SV
ENDA
TEMPERATURE CONTROLLER
SET
CSET ASET
CNT/AL2
SSR
AL1
TEMPERATURE CONTROLLER
ENDA
ETC 7420
CNT/AL2
SSR
AL1
PV
SV
ASET
CSET
SET
48mm
58mm
72mm
78mm
96mm
102mm
98mm
96mm
TEMPERATURE CONTROLLER
ENDA
PV
SV
CSET
ASET
SET
ETC 4420
CNT/AL2
AL1
SSR
°C
°C
°C
°C
°C
+32... +1112
+32... +2192
+32... +752
+32... +2912
+32... +2912
°C
°C
-328... +1112
-99.9...+543.0
51mm
ETC8420
* Selectable sensor type.
* Automatic calculation of PID parameters (SELF TUNE).
* Soft-Start.
* Communication vai RS-485 ModBus protocol (Optional).
* Selectable SSR or relay control output.
* Relay output can be programmable as second alarm or control output.
* AL1 relay output for first alarm out.
* Selectable Heat/Cool control.
* Input offset feature.
* In the case of sensor failture periodical running or relay state can be
selected.
* Parameter access protection on 3 levels.
* Programming by using keypad or Modbus.
* CE marked according to European Norms.
TECHNICAL SPECIFICATIONS
J (Fe-CuNi) Thermocouple
K (NiCr-Ni) Thermocouple
T (Cu-CuNi) Thermocouple
S (Pt10Rh-Pt) Thermocouple
R (Pt13Rh-Pt) Thermocouple
EN 60584
EN 60584
EN 60584
EN 60584
EN 60584
0... 600
0...1200
0... 400
0...1600
0...1600
Pt 100 Resistance thermometer
Pt 100 Resistance thermometer
EN 60751
EN 60751
-200...600
-99.9...300.0
Input type
104mm
90.5mm
90.5mm
ETC9420
ETC7420
°F
°F
°F
°F
°F
°F
°F
90.5 mm
45 mm
+0.6
+0.6
TERMS
State indicator
PV display
PV Display :
Process value during normal operation
Mnemonic parameter code during programming
SV Display :
Set point during normal operation
Date value during programming
SÝSEL MÜHENDÝSLÝK ELEKTRONÝK SAN. VE TÝC. A.Þ.
Tel : +90 216 499 46 64 Pbx. Fax : +90 216 365 74 01
100mm
75mm
68 mm
+0.7
1
Yukarý Dudullu Barbaros Cad. Kutup Sk. No:20 34775 - ÜMRANÝYE/ÝSTANBUL-TÜRKÝYE
Note : 1) While panel mounting, additional distance required for
connection cables should be considered.
2) Panel thickness should be maximum 9mm.
3) If there is no 100mm free space at back side of the device,
it would be difficult to remove it from the panel.
4/4
ETCXXXX-E-02-R-A3
1/4
Read this document carefully before using this device. The guarantee will be expired by damaging of the device if you don’t attend to the
directions in the user manual. Also we don’t accept any compensations for personal injury, metarial damage or capital disadvantages.
ENDA ETC SERIES PID TEMPERATURE CONTROLLERS
Thank you for choosing ENDA ETC SERIES temperature controllers
Enter PID parameters of the system if they are known at the begining.
Otherwise, Self-Tune should be activated.
99mm
7 segment, 4 digits,
red LED indicator
yellow LED ind.(ETC8420)
Decrement key during
normal operation
If only this key is pressed
in normal operation,
software version number is seen
Increment key during normal
operation and programming
Parameter selection key
during programming
Alarm set key
during normal operation
Menu selection key
during programming
Control set key
during normal operation
Parameter selection key
during programming
3 red LEDs for
Control, Alarm1 and
SSR outputs
ETCXXXX-E-02-R-A3
url : www.enda.com.tr
SV display
Character
heights
Keypad
7 segment, 4 digits,
yellow LED indicator
Mikro Switch
PV display :
7mm(ETC4420)
12.5mm(ETC8420)
14mm(ETC7420)
20.3mm(ETC9420)
SV display :
7mm(ETC4420)
12.5mm(ETC8420)
10.2mm(ETC7420)
14mm(ETC9420)
84mm
68 mm
+0.7
51mm
80mm
45 mm
+0.6
45 mm
+0.6
ETC4420
Panel cut-out:
DIMENSIONS
80% up to 31 decreasing linearly 50% at 40 .
0 ... +50 /
-25... +70
°C
°C
°C (with no icing)
According to EN 60529 Front panel : IP65
Rear panel : IP20
ENVIROMENTAL CONDITIONS
Ambient/storage temperature
Max. Relative humidity
Rated population degree
°C
230VAC +%10 -%20 or 24VAC ±%10, 50/60Hz or by your choose 9-30VDC / 7-24VAC ±%10 SMPS
Max. 7VA (For ETC4420 5VA)
2.5mm² screw-terminal connections
EN 61326-1:1997, A1:1998, A2:2001 (Performance criterion B for standard EN 61000-4-3)
EEPROM (minimum 10 years)
For thermocouple max. 100ohm, for 3 wired Pt 100 max. 20ohm
EN 61010-1: 2001 (Pollution degree 2, overvoltage category II)
Single set-point and alarm control
On-Off / P, PI, PD, PID (selectable)
Better than 15 bits
500ms
Adjustable between %0 and %100. If Pb=%0, On-Off control is selected.
Adjustable between 0.0 and 100.0 minutes.
Relay : 250V AC, 2A (for resistive load), Selectable as Control or Alarm2 output.
Mechanical 30.000.000 operation; Electrical 300.000 operation
Relay : 250V AC, 2A (for resistive load), NO/NC selectable. (Alarm1 output).
Max. 2000m
Do not use the device in locations subject to corrosive and flammable gases.
0,2% (of full scale)
1 digit
Height
Supply
Power consumption
Wiring
Line resistance
Data retention
EMC
Safety fequirements
Accuracy
ELECTRICAL CHARACTERISTICS
OUTPUTS
CONT./AL2
AL1
Life expectancy for relay
CONTROL
Control type
Control algorithm
A/D converter
Sampling time
Propotional band
Ýntegral time
Suitable for flush-panel mounting according to DIN 43 700.
HOUSING
Housing type
Adjustable between 0.00 and 25.00 minutes.
Adjustable between 1 and 250 seconds.
Adjustable between 1 and 50 .If inP=Pt.0, adjustable between 0,1 and 50 )
The ratio of power at a set point can be adjusted between 0% and 100%
°C/F
Derivative time
Control period
Hysteresis
Output power
SSR out
Selectable logic control output. (Max 12V 20mA).
ETC4420 : G48xY48xD87mm ETC7420 : G72xY72xD97mm
ETC8420 : G48xY96xD87mm ETC9420 : G96xY96xD50mm
Approximately 400g after packing (For ETC4420 250g).
Self extinguishing plastics.
While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive materials must not be used.
Dimensions
Weight
Enclosure material
Temperature range
Order Code : ETC   -      - 
1 2 3
1 - Dimensions
4420.....48x48x87mm
7420.....72x72x97mm
8420.....48x96x87mm
9420.....96x96x50mm
2 - Supply Voltage
230VAC...230V AC
24VAC.....24V AC
SM...........9-30V DC /
7-24V AC
3 - Modbus Option
RS.........RS-485 Modbus
communication
None.....Don’t support RS-485
Modbus comm.
°C/F
AL1
CNT/AL2
SSR
TEMPERATURE CONTROLLER
ETC 9420
ENDA
PV
SV
SET
ASETCSET
ETC 8420
PV
SV
ENDA
TEMPERATURE CONTROLLER
SET
CSET ASET
CNT/AL2
SSR
AL1
TEMPERATURE CONTROLLER
ENDA
ETC 7420
CNT/AL2
SSR
AL1
PV
SV
ASET
CSET
SET
TEMPERATURE CONTROLLER
ENDA
PV
SV
CSET
ASET
SET
ETC 4420
CNT/AL2
AL1
SSR
CSET
SET
ASET
Connection
cables
- While pressing both side of
the device in direction 1, push it
in direction 2.
For removing the device from
the panel:
Panel
Flush mounting
clamp
1
2
1
87mm
Depth
Enviroment temperature
measurement sensor
Depth
97mm
2
Rubber packing
Flush mounting
clamp
Panel
-While pressing both side of
the device in direction 1, push it
in direction 2.
For removing the device from
the panel:
Connection
cables
Enviroment temperature
measurement sensor
Depth
87mm
1
2
Panel
Gasket
Flush mounting
clamp
-While pressing both side of
the device in direction 1, push it
in direction 2.
For removing the device from
the panel:
Enviroment temperature
measurement sensor
-While pressing both side of
the device in direction 1, push it
in direction 2.
For removing the device from
the panel:
57mm
Panel
Gasket
2
Flush mounting
clamp
50mm
Depth

ENDA ETC 4420 Specifications

General

Brand	ENDA
Model	ETC 4420
Category	Controller
Language	English