ENDA ETC1311 - Device Operation and Parameters; Operating Modes; Parameter Table; Error Messages

Switch hysteresis
for the setpoint.
Access code for menu of security.
Enter then press key.311
When pressed or key, temperature set value flashes and by using and keys the value can be adjusted.
If no key is pressed for 3 seconds run mode is returned.
Aco
Ase
Programming Mode
Run mode
Process
Value
200
199
200
Hys
Cod
SeC
1000
If key is pressed and held for 3 seconds,
programming mode is entered.
100
SET
Security parameter for menu of configuration.
Security parameter for temperature set value.
If key is pressed,
run mode is entered.
Used for adjusting the value of the setpoint in the run mode and for adjusting the selected parameter in the programming mode.
While holding key, setpoint value of the selected parameter appears and by using and keys the value can be adjusted.
Used for selecting menu and increasing setpoint value of the parameters in the programming mode and for
increasing the setpoint value in the run mode. When held down for a few seconds, the change rate accelerates.
Used for selecting parameters and decreasing the setpoint value in the programming mode and for decreasing
the setpoint value in the run mode. When held down for a few seconds, the change rate accelerates.
Displayed process value in the run mode, parameter name or value in programming mode.
SET
SET
Means, temperature value is higher than the scale.
Error Messages
Pfa
Means, temperature value is lower than the scale.
Means, temperature sensor is broken or over temperature.
Non
Pye
Pno
= Menu is invisible.
= Parameters of menu are changeable.
= Parameters of menu are only visible.
= Set value is changeable.
= Set value is only visible.
Pye
Pno
The upper limit
of the setpoint.
In the case of error,
on time rate of
the relay output.
The lower limit
of the setpoint.
Upl
Eon
Con
Lol
In the case of error,
period of
the relay output.
Ect
Offsetvalue (can be adjusted
from -99...+99C°)
oFS
---
___
Switch hysteresis for the setpoint. (When temperature
falls to SET-HYS, output relay becomes active.)
Menu of Configuration parameters
PARAMETER TABLE
The upper limit of the setpoint.
In the case of error, on time rate of the relay output.
The lower limit of the setpoint.
In the case of error, period of the relay output.
Offsetvalue (can be adjusted from -99...+99C° to a desired value)
Hys
Aco
ASE
Upl
Eon
LoL
Ect
oFS
SEC
Con
Security parameter for menu of configuration.
Menu is invisible.
Parameters of menu are changeable.
Parameters of menu are only visible.
Non
Pye
Pno
=
=
=
Security parameter for temperature set value.
Set value is changeable.
Set value is only visible.
Pye
Pno
=
=
Menu of Parameter security
0 °C 0UPL
10 250 sec 30
1 20 °C 1
°C 600
LoL 600
0 100 0% Ect
MIN MAX UNIT DEF.SET
If no key is pressed
for 3 seconds
2./2ETC1311-E
HEATING OUT
LED
SET
PRG
ETC1311
ENDA
OUT
°C