Wireless Controller (EP1 or EP2) 60Hz
Power Unit Not Turning On
Rev 7/16/10
Clearing receiver / programming transmitter instructions
Clear the memory by pressing and holding the LEARN button until
the upper LED turns on a solid red and then turns off (this may
take up to 30 seconds)
Once the memory is cleared, reprogram ALL the transmitters one
at a time using the following steps;
- press and hold the LEARN button until the upper LED is a solid
and steady red (this may take up to 10 seconds)
- release the LEARN button
- press and hold any one of the buttons on a transmitter
The transmitter is successfully programmed when the LED turns
off momentarily and then flashes in response to the held button
To Previous Page
Loading...
