7
LP Gas Outdoor Fire Pit
Model No.: GAD19102ES
Assembly Instructions (continued)
6
Attach Door Knob and Door and Turn Outdoor Fire Pit
Over
W CAUTION: Two (2) people will be required to turn the outdoor
fire pit upright on feet.
B
x 1
D
x 1
7
Place Fire Glass
W CAUTION: Do NOT dump fire glass out of package. Carefully
place fire glass by hand so dust does not clog burner.
W CAUTION: Use only Mr. Bar-B-Q Products LLC factory-
authorized fire glass. The use of any fire glass that is not
factory-authorized can be dangerous and will void your
warranty.
W CAUTION: Do NOT cover igniter cover.
Note: Fire glass should be 0.8-1.6 in (2-4 cm) diameter. Approx. 11 lbs (5 kg) of fire
glass is needed.
8
Place Table Insert
W WARNING: NEVER place table insert on outdoor fire pit while
in use.
W WARNING: NEVER place table insert on outdoor fire pit while
the outdoor fire pit is still hot.
5
Attach LP Gas Tank Prevent Bar to Base, then Attach
Base
Note: Tighten all screws from steps 2-5.
A
x 2
C
x 4
A
C
D
B
To Next Page
Loading...
