
Do you have a question about the Endless Summer Kingston and is the answer not in the manual?
| Brand | Endless Summer |
|---|---|
| Model | Kingston |
| Category | Outdoor Fireplace |
| Language | English |
Appliance produces odorless carbon monoxide. Use only in well-ventilated areas to avoid suffocation risk.
Follow gas leak instructions to prevent fire or explosion. Property damage, injury, or death may result.
Read manual, use only outdoors, keep area clear, do not use for cooking.
Know LP gas odor, get away from leaks, call fire dept. Do not use indoors or in garages.
Use outdoors only, check for leaks with soapy water, ensure proper connections before lighting.
Use only outdoors, 10ft clearance from structures, not for commercial use, avoid balconies.
LP gas is flammable, heavier than air. Use DOT-approved tanks, store outdoors, away from heat.
Perform leak test before lighting using soapy water, no smoking. Correct leaks before operation.
Do not use if submerged, avoid loose clothing, no windy conditions, keep children/pets away.
Surfaces become very hot. Do not touch until cooled (approx. 45 mins). Use protective gear.
Inspect hose, clean annually, use factory-authorized parts. Disconnect gas before servicing.
Diagram illustrating all parts of the fire pit with their corresponding numbers.
List of screws, batteries and tools needed for assembly.
Select assembly area, spread parts, attach legs. Two people needed for turning.
Attach side/rear panels and base components. Do not fully tighten screws until step 4.
Attach door, insert battery, and carefully place fire glass. Do not cover pilot housing.
Place the table insert. Never place while in use or while hot.
Instructions for inserting, securing, and connecting the LP gas tank, including leak checks.
Procedure for safely disconnecting the LP gas tank and storing it properly.
Procedure for checking gas connections for leaks using soapy water solution.
Ensuring proper burner connections and safe lighting procedures for the fire pit.
Steps for turning off the appliance and basic cleaning guidelines.
Inspect burner, clean ports, replace parts, and prepare for storage indoors or outdoors.
Register product for warranty service and understand the terms of the limited warranty.
Resolving problems with the burner not lighting using igniter or match.
Addressing issues like low flame, irregular flame, flashback, or flame extinguishing.
Troubleshooting flame loss due to ice buildup on the LP gas tank in cold weather.









Loading...