Device configuration, application setup Graphic Data Manager
20
"Required inputs"
submenu
Specify which data fields must be input before a batch can be started. A batch cannot be started until the
selected required fields have been input.
Fig. 2: Setup - Application - Batch mode, "Required inputs" submenu
Identifier Specify if the batch designation must be input so that a batch can be
started. Picklist: no, yes
16070/000
Batch name Specify if the batch name must be input so that a batch can be started.
Picklist: no, yes
16071/000
Batch number Specify if the batch number must be input so that a batch can be started.
Picklist: no, yes
16072/000
Preset counter Specify if the preset counter must be input so that a batch can be started.
If "no", the last preset counter is reused.
!
Note!
Only relevant if batch is ended per preset counter.
Picklist: no, yes
16073/000
"Application -
Batch mode"
menu items
Configurable parameters
(factory settings are highlighted in bold)
Direct access
code
To Next Page
Loading...
