Graphic Data Manager Device configuration, application setup
19
2.2 Setup - Application - Batch mode
Required settings for batch mode.
!
Note!
Depending on the selected function, the device's user interface adapts itself, so that each time only
parameters that are required for safe unit functioning have to be checked/set.
Fig. 1: Setup - Application - Batch mode
"Application -
Batch mode"
menu items
Configurable parameters
(factory settings are highlighted in bold)
Direct access
code
The device processes The device can record up to 4 batches simultaneously. Configure how many batches the device should process
simultaneously. Picklist: Switched off, 1 batch per device, x batches simult. per device
16000/000
Batch number Configure how the batch number is generated:
"Manual": You can enter any text as the batch number.
"Increase automatically": the batch number is automatically increased by 1 after the batch is finished.
16030/000
Autom. batch readout Activate this function to make the PC software automatically read out the data and print it out as soon as the
batch is finished.
!
Note!
Only available if the device is connected via Ethernet and the readout automation system is started in the PC
software.
Picklist: no, yes
16035/000
IP address Enter the IP address of the reader PC here. Where necessary, contact your network administrator to find out
the IP address. Factory setting: 000.000.000.000
16040/000
Port A connection to the reader PC is established through this communication port.
!
Note!
If your network is protected by a firewall, this port may have to be enabled. In such instances, contact your
network administrator.
Factory setting: 0
16055/000
To Next Page
Loading...
