To Next PageTo Next Page
Need help?Do you have a question about the Enegic Monitor and is the answer not in the manual?
General| Brand | Enegic |
|---|---|
| Model | Monitor |
| Category | Controller |
| Language | English |
Open electrical cabinet, locate phase conductors (L1, L2, L3), and guide cables out.
Connect current sensors to phase conductors and plug into terminal block; connect power cables.
Check if the device is in configuration mode; reset if necessary by pressing the button.
Log in to the Enegic app, impersonate the customer account, and configure the new physical device.
Scan Easee license QR-code, add a new virtual device, and add a new reporter.
Select 'Easee Control' as reporter, enter charger details, and save Enegic monitor selection.
