5
WARNING: Do not continue with the installation or repair until the electrical circuit
is proven electrically dead.
INSTALLATION
Fully read and understand the directions before installation.
Refer to addi tional safety information at the end of this
document.
1
2
3
Isolate the electrical circuit.
Use a 2-pole voltage detector to ensure that there is no
power at the hardwire connection.
Use the 2 screws to secure the wall bracket to the wall:
Wood installation: Use a stud sensor to determine an
appropriate mounting location, then use the 2 screws to
secure the wall bracket.
To Next Page
Loading...
