14
1. Make use of the buttons to select between the different operating parameters.
2. To change an operating value, press the SET button once. (Quickly)
(The parameter number “At the bottom” will not be flashing anymore, but the
current setting “Indicated between the lines” will continue to flash)
Note: If both continue to flash, please ensure the heat pump is in Standby mode.
3. Make use of the buttons to change the value to the desired or default value.
4. Press the SET button to confirm the setting and return to selecting an operating parameter.
(To change the values of these parameters, repeat steps 3 to 6.)
5. To exit this mode automatically, wait for 5 seconds without pressing any buttons
or press the Obutton to exit manually.
To Next Page
Loading...