19
PLEASE NOTE THE FOLLOWING:
1.
Outdoor temperature, water inlet temperature and parameter settings may
affect the performance and power consumption of the heat pump unit.
2.
Ensure that the heat pump air flow is not blocked.
3.
If the ambient temperature is too high, the fan may stop working temporarily in
order to protect the system. The heat pump will however still provide hot water
to the geyser. If the temperature decreases the fan will resume operation again.
4.
If the unit enter the defrosting mode the fan may stop working temporarily.
Once the evaporator coil temperature has reached an acceptable level, the fan
will resume operation.
5.
Ensure that the unit is well ventilated and that no cold air is redirected back into
the evaporator (i.e. do not install the heat pump in small enclosed rooms).
6.
Ensure that all the isolation valves are open before the heat pump is turned on.
To Next Page
Loading...