5
Heating
Mode
Fast
Heating
Mode
The user can select between standby mode and heating mode by pressing the
Obutton.
The user can also activate a fast heating mode by pressing the M button.
This will activate both the backup element inside the geyser and the heat pump to
work simultaneously to heat the water.
NOTE:
Fast heating mode activates the electrical element which will lead to more
energy consumption and should only be used in the exemption when reheating time
needs to be reduced due to a temporary higher demand of hot water.
!
WARNING
Do not turn off main power supply to the heat pump during a vacation or
if not in use. The heat pump must have electricity in order to protect itself during cold
climate conditions. It is recommended that the heat pump is placed in standby mode
with all timers removed and the target temperature set at 25°C to keep the heat pump
from heating the water.
Initialization phase Ready for Operation
To Next Page
Loading...