Energetiq EQ-99 Manager - Introduction and Safety; Safety Terms and Symbols

EQ-99 Manager User’s Manual · Page 3
Introduction
The Energetiq EQ-99 Manager is a smart control system for operating the EQ-
99 Laser Driven Light Source and optional shutter. The front panel has LED
indicators for the lamp on/off state and shutter position, and the VFD display
provides additional status indication as well as the ability to change the
operation of the instrument by adjusting the instrument settings through the
menu. A trigger input on the front panel allows for synchronization of the shutter
with other instruments, with exposure mode control or simply open/close
operation. A USB interface is available for full operation from a computer.
The Energetiq EQ-99 Manager also provides the 12VDC power needed by the
EQ-99 Power Supply Controller.
Safety Terms and Symbols
The following safety-related terms are used in this manual:
 Warnings (noted by the WARNING heading) explain dangers that
could result in physical injury or death;
 Cautions (noted by the CAUTION heading) explain conditions that
could result in damage to the instrument, other equipment, or your
device.
 Notes (noted by the NOTES heading) are not safety-related, and are
intended simply to point out important information.
If, at any time, any of the following conditions exist, or are suspected of existing,
discontinue use of the unit until it can be inspected by qualified service
personnel:
 Visible damage to the unit, including damage or stress caused during
product shipment;
 Storage of the unit outside the standard storage temperature or
humidity rating, or prolonged storage under harsh conditions;
 Failure to operate properly.
If needed, contact your distributor or Energetiq for service or repair to ensure the
safety of the product is maintained.