Energic Plus RE Series User Manual

Energic Plus RE Series

24 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

BATTERY CHARGER

BATTERY CHARGER

RE

RE

USER'S MANUAL

USER'S MANUAL

Questions and Answers:

W
William LeeAug 14, 2025
What to do if Energic Plus Battery Charger does not react and LED is OFF?
- R
  richashleyAug 14, 2025
  If your Energic Plus Battery Charger doesn't react when connected to the battery and the LED panel remains off, there are several possible causes. First, check the battery connectors and harness to ensure they are properly connected. It's also possible that the charger has been connected to the forklift motor connector instead of the battery, so disconnect the forklift motor and connect the battery. Also verify the polarities of the charger, connectors, and battery, as reversed output cables can cause this issue and potentially blow the output fuse. Inspect the board connectors (green) for bad connections. In some cases, the control board itself may be faulty and need replacement.
M
Marissa WilliamsAug 17, 2025
What to do if my Energic Plus RE Battery Charger smells hot?
- J
  Jill DickersonAug 17, 2025
  If your Energic Plus Battery Charger smells hot, consider these potential causes. Ensure the charger is installed in a proper location with adequate ventilation. Remove any objects obstructing the ventilation slots. Check and tighten all power wirings if they are bad or loose. Also, wrong AC input settings can cause overheating, so adjust the AC input settings to a higher voltage if needed. In some cases, the transformer may be burned and require replacement.

Energic Plus RE Series Specifications

General

Output Voltage	12V DC
Battery Type	Lead Acid (AGM, Gel, Wet)
Protection	Overcharge, Short Circuit, Reverse Polarity
Charging Time	Varies depending on battery capacity
Compatibility	12V Lead Acid Batteries

Summary

2. Safety Instructions and Warnings

General Safety Precautions

Observe safety rules and take precautions to prevent injury or equipment damage.

Shock Prevention

Learn about electrical hazards and grounding to prevent fatal shocks.

Installation and Grounding

Electrical equipment must be installed per codes; ensure proper grounding.

Charging Leads and Battery Terminals

Inspect leads for damage; avoid touching terminals during operation.

Service and Maintenance Safety

Shut off power before servicing; disconnect battery and check capacitors.

Burn and Bodily Injury Prevention

Fire and Explosion Prevention

4. Installation

General Installation Precautions

AC Input Voltage Adjustment - Cabinets S, A, B

AC Input Voltage Adjustment - Cabinet C

5. How to Use the Charger [Cabinets S, A, B]

Start of Charge

Charge Cycle

Equalization

6. How to Use the Charger [Cabinet C]

Preliminary Controls

LED Control Panel Overview

7. Trouble Shooting Guide

8. Trouble Shooting Guide

Related product manuals

Preview: Energic Plus RX

Energic Plus RX

Preview: Energic Plus BATTERY CHARGER RX

Energic Plus BATTERY CHARGER RX

Preview: Energic Plus TSS-D

Energic Plus TSS-D

Preview: Energic Plus NG1

Energic Plus NG1

Energic Plus LF5