ENERpower VLCD-5 - General Information; Installation

ENERdan GmbH | Max-Planck-Straße 7, D-12489 Berlin, Deutschland |www.enerpower.de
Tel: +49 (0) 30 5770 344 35 | Fax: +49 (0) 30 5770 344 39 | sales@enerdan.de
3
1. General Information
This intelligent VLCD-5 device is designed especially for electric bicycle. It’s mainly used to control
the power assist, to show the consumption and charge status of the battery, to measure and show
the speed of the bicycle and to record the trip distance.
This manual will guide you through the functionality of the device and its features. Read the manual
carefully to familiarize yourself quickly with the device. Expert advice, along with regular care and
maintenance can extend the lifetime of your product!
2. Installation
Mount the display on the handlebar and connect it. Please refer to Image 1, 2 and 3
1. Mount the set on the handlebar using the display-pedestal.
2. Connect the display to the remote control.
3. Insert the brake-levers plugs into the back of the display.
4. Connect the display to the motor.
Connection between the
display and the controller
Connection between the
display and the motor
Controller
Connection between the
display and the brake levers
Image
1
-
display installation
Image
3
-
Display Pedestal
Connect to the motor
Connect to the controller
Image
2
-
VLCD
-
5 Display