ENERdan GmbH | Max-Planck-Straße 7, D-12489 Berlin, Deutschland |www.enerpower.de
Tel: +49 (0) 30 5770 344 35 | Fax: +49 (0) 30 5770 344 39 | sales@enerdan.de
8
Error Codes Explained
Motor general fault or motor short circuit
Turn on the motor with cyclist’s
feet on the pedal for coaster brake version
5.4 Settings Mode
Enter Settings Mode
To show the hidden settings, press the Power and the Info buttons simultaneously for 3 seconds on
the startup screen, then quick press the Info button 4 times, you will then see the first setting. If you
leave the setting menu for a few seconds, the display will exit the settings mode.
There are 11 levels of mode (odometer, trip distance, average speed, single trip time, wheel
diameter selection, magnet number selection, speed unit selection, 6/Km/h function selection, top
speed selection, power adjustment selection, mode selection). Default is odometer.
Wheel Diameter Selection (d1)
Use the Info button to enter the speed selection, then press + or - button to choose the correct
diameter (in inches). The default value is 26“.
Note that setting up the wheel diameter is crucial in order to allow the system to correctly calculate
the bicycle‘s speed and the trip distance.
Image 11 - Wheel Diameter Selection (d1)
Spoke magnet number selection (cc)
Use the Info button to enter the magnet number selection, press the + or – buttons to choose the
number of magnets 1-12. The default is 1.
The number represents the number of pulses from one complete rotation of the wheel.
Wheel diameter
(in inches)
To Next Page
Loading...