ENFORCER E-920A User Manual

VOICE DIALER Installation Manual
SECO-LARM U.S.A., Inc.Page 2
A. DC adapter jack
B. Siren output jack
C. Sensor input modular connector
D. Telephone line modular connector
E. Speaker
F. 9VDC battery compartment
G. Microphone
H. Dial keys
I. Power switch
J. LCD display
K. MODE button — 3 selections:
1. PROGRAM — Telephone no. and
voice message recording
2. TEST — Telephone no. and voice
message testing
3. OPERATE— Armed condition
L. MEMORY button — For recording
telephone no.
M. VOICE button — For recording voice
message.
N. DIP Switches:
1 Exit delay (1 or 120 seconds)
2. Entrance delay (1 or 30 seconds)
3. Tone/pulse telephone
4. Regular/PBX telephone
5. Trigger input — 2-time redial
enabled/disabled (for voice
message #1 and #2)
6. Not used.
How It Works ..........................................1
Controls and Connections ....................... 2
Wiring Diagram ...................................... 3
Connecting the E-920A ........................... 3
Setting the DIP Switches........................... 4
Storing Telephone Numbers .................... 5
M
H
G
E
F
D
C
B
A
J
K
L
I
TABLE OF CONTENTS
Erasing Memory ...................................... 6
Storing Pager Numbers & Access Codes .. 6
Recording Messages ............................... 7
Specifications .......................................... 7
Testing the Unit — Self-Test ...................... 8
Testing the Unit — Operate Mode ........... 8
CONTROLS AND CONNECTIONS
N
ENFORCER
®
Voice Dialer

ENFORCER E-920A Specifications

General

Brand	ENFORCER
Model	E-920A
Category	Intercom System
Language	English