EngA ENGINEERED AIR base - Page 2

base A
2
IOM74 November 2020 R105
INTRODUCTION
This technical manual is intended for technicians
and factory personnel already familiar with the
operation of Engineered Air equipment, control
strategies and combustion setup.
The base and CD-XM expansion module have been
certified by Intertek (ETL) for use with Engineered
Air appliances only, evaluated to CSA 22.2 No. 24
Temperature Indicating and Regulating Equipment
and UL873 Standard for Safety Temperature
Indicating and Regulating Equipment.
If any errors or omissions are noted, please contact
the nearest Engineered Air Technical Service
Department.
To ensure the warranty is honored, only qualified
personnel should be employed for service or
troubleshooting. If further information is required,
please contact the nearest Engineered Air sales
office.
Copyright
This document and the information in it are the
property of Engineered Air and may not be used or
reproduced in whole or in part without written
permission. Engineered Air reserves the right to
revise this publication at any time, and to make
changes to its content without obligation to notify
any person of such revision or change.
CONTACT INFORMATION
Canadian Head Office and Factory
1401 Hastings Cres. SE
Calgary, Alberta, Canada
T2G 4C8
PH: (403) 287 2590
Email: service@engineeredair.com
USA Head Office and Factory
32050 W. 83
rd
Street
De Soto, Kansas, USA
66018
PH: (913) 583 3181
Canadian Eastern Factory
1175 Twinney Drive
Newmarket, Ontario, Canada
L3Y 5V7
PH: (905) 898 1114