To Next PageTo Next PageWhat to do if my Engel TV Receiver remote control is not responding?
If your Engel TV Receiver remote control isn't responding, the battery may be exhausted, so try changing the battery. Alternatively, the remote control might not be facing or close enough to the set-top box. Adjust the position of the remote control and move closer to the unit.
Why is there no picture on my Engel TV Receiver?
If there is no picture on your Engel TV Receiver, ensure the power is connected. If it is, check that the power switch is turned on. Switch it on if it's off.
What to do if my Engel rt5130u TV Receiver screen shows “No Signal”?
If your Engel TV Receiver screen displays “No Signal”, the DVB-T cable may not be connected. Plug in the DVB-T cable. Also, the aerial cable might be faulty, so check the aerial cable and its connections.
How to fix no sound from Engel rt5130u TV Receiver speaker?
If there's no sound from your Engel TV Receiver speaker, it could be due to no or an incorrect connection with the audio cable. Ensure you connect the audio cable correctly. Also, check if the sound is muted and turn off the mute function.
Why is my Engel TV Receiver showing only sound and no image?
If your Engel TV Receiver is showing only sound and no image, it could be due to several reasons: * The resolution may not be supported by your TV set. Try pressing the Red Color button to change the resolution. * There might be no or an incorrect connection with the AV cable. Ensure that the cables are connected correctly. * The program may be a radio program. Press the key to switch to TV mode.
What causes picture breakup on my Engel rt5130u?
If the picture on your Engel TV Receiver is breaking up, the signal might be too weak. Check the aerial cable and connections to ensure they are secure.
General| Model | RT5130U |
|---|---|
| EPG | Yes |
| Teletext | Yes |
| Subtitles | Yes |
| Audio decoding | MPEG-1 Layer I & II |
| Connectors | HDMI, USB |
| Resolution | 1080p |
| Video decoding | MPEG-2, MPEG-4, H.264 |
Identifies components on the front, rear, and side panels.
Guidance on positioning the STB and connecting cables.
Using the remote and performing the first-time installation wizard.
Managing channels, editing programs, and performing channel searches.
Adjusting language, AV, time, OSD, and other system options.
Accessing system info, factory reset, timers, and software upgrades.
Using media players, record manager, and DVR timeshift features.
