ENGINDOT HS60 - Measurement and Calculation Functions; Self-Calibration; Single Distance Measuring; Continuous Measuring

To Next Page

To Previous Page

This function can keep the precision of the device.

Instruction: Power off, Long press button , and

then press . Release the button , then

"CAL" and a figure shows on the screen. User can

adjust the figure with button according to the

accuracy of the meter. Adjusting range: -9 to 9mm,

then, long press button to save the calibration

result.

Self-Calibration

Length Measurement & Calculation

Continuous Measuring:

Single Distance Measuring:

Turn on the laser beam by short press of the

button under measuring mode, press the

button again for single measurement of length,

then the measured results displayed in the major

display area.

Long press button under measuring mode

and enter into continuous measuring mode

Maximum measuring result displays in auxiliary

display area, present result displays in major

display area. Short press button or to exit

continuous measuring mode.