Need help?Do you have a question about the Engl Cabloader and is the answer not in the manual?
General| Brand | Engl |
|---|---|
| Model | Cabloader |
| Category | Music Pedal |
| Language | English |
Overview of the CABLOADER as a full-featured speaker cabinet simulator, IR loader, and DI box for transforming guitar rigs.
Lists the main capabilities including built-in cab models, 3rd party IR loading, power amp and mic emulations, DI box functionality, and footswitch controls.
Details the front panel controls like CAB, POWER AMP, MASTER, MIC, FAVOURITE A/B, CLIP LED, DC IN, and USB port.
Describes the rear panel connections including PHONES, GROUND LIFT, XLR OUTPUT, UNBALANCED OUTPUT, INPUT, and THRU.
Illustrates a setup using the CABLOADER to transform gain pedals into a full sounding amp rig for PA or audio interface connection.
Shows how to connect the amplifier's preamp section directly to PA or audio interface with THRU output for speaker monitoring.
Explains how to save and recall up to two favorite cab setups using the FAVOURITE A and B footswitches.
Details how to engage and disengage bypass mode, including the operation of LEDs and footswitches.
Lists the 12 built-in cabinet models, their sizes, and the speakers they are based on, plus user slots for 3rd party IRs.
Lists the available microphone models and the original microphones they are based on for simulation.
Describes the process of loading custom cabinet IR files using the proprietary software via USB.
Provides key technical details including outputs, USB port type, sampling rate, accuracy, signal-to-noise ratio, power requirements, and dimensions.
To Next Page
