FX Loop (serial FX Loop)
In the signal path, the FX Loop is located post preamp and before the power amp Master controls.
FX Loop Send
Connect the FX Loop Send (output) to a signal processor´s input or an effect pedal´s input/return jack
using the shortest possible shielded instrument cable (conventional 6.3mm / ¼“ TS cable).
FX Loop Return
Connect the FX Loop Return (input) to a signal processor´s output or an effect pedal´s output/send jack
using the shortest possible shielded instrument cable (conventional 6.3mm / ¼“ TS cable).
Reverb Mix Level
This control adjusts mix of dry signal to wet Reverb signal and increases it´s intensity if you rotate it
clockwise.
Headphone Output
Connect a headphone (conventional 6.3mm / ¼” TRS cable) for easy monitoring or practice. When selecting
the Power Soak “Speaker Off” position you can practice without disturbing your neighbours.
CAUTION! When powering the amp up, upcoming noise can appear and damage hearing. Make shure to
remove the headphones while powering the device up.
Line Output – Cab Sim
The Line Output – Cab Sim port taps the power amp‘s output to provide a line out signal configured at a level
of about 0 dB. The signal ist filtered to simulate the effect a speaker cabinet has on the signal.
Line Output – Pure Signal
The Line Output – Pure Signal port taps the power amp‘s output to provide a line out signal configured at a
level of about 0 dB. The frequency response is identical to the power amp output signal. In other words, its
frequency response is not compensated or corrected. You can feed this signal to another linear power amp.
Another option is to patch it through an outboard filter to emulate a speaker, or for example into the ENGL
CABLOADER (IR-Loader with an integrated microphone and poweramp simulation), and feed this externally
processed signal to a recording device or PA system.
Poweramp Output
E600 Ironball Combo: The internal 12" speaker is connected to this output.
E606 Ironball Head: A single 8-16 ohm cabinet can be connected to this output.
Important Note: We cannot stress enough the importance of proper impedance matching when connecting
one or more cabinets to your amp. Impedance mismatching can damage the poweramp! Always check the
connected cabinet´s impedance to confirm it matches the amp´s output impedance!
To Next Page
Loading...
