Need help?Do you have a question about the Engl Gig Master 30 and is the answer not in the manual?
General| Brand | Engl |
|---|---|
| Model | Gig Master 30 |
| Category | Musical Instrument Amplifier |
| Language | English |
1/4" unbalanced input jack for connecting your guitar.
Controls preamp's input sensitivity for Clean/Lead channels.
Controls Lead channel's sensitivity and preamp distortion.
Controls the bottom end voicing of the preamps's passive EQ.
Controls the mid-range voicing of the preamps's passive EQ.
Controls the upper range voicing of the preamps's passive EQ.
Reverb intensity knob to adjust reverb amount for Clean and Lead.
Volume control for the Lead channel.
Master volume knob controls the power amp's output.
Boosts specific midrange frequencies when activated.
Increases Clean and Lead channels' amplitude.
Pushbutton for selecting between Clean and Lead modes.
Indicator for a blown internal power tube fuse.
Power amp standby switch to silence the amp during breaks.
AC power on/off switch.
AC power inlet (IEC - C14 connector) for mains cord.
Contains the mains fuse and a spare fuse.
Jack for connecting a footswitch to control FX Loop and Reverb.
Jack for connecting a footswitch to control Mid Boost and Master Volume Boost.
Jack for connecting a footswitch to control channels and Gain Boost.
Output for connecting to a signal processor's input.
Input for connecting an effects device's output.
Taps power amp's output for a line out signal.
8-ohm speaker out for cabinets or internal speaker.
Parallel 8-ohm speaker out for connecting two 16-ohm cabinets.
Serial 16-ohm speaker out for connecting a 16-ohm cabinet.
Auxiliary 16-ohm serial output for two 8-ohm cabinets.
Specifies power rating and input sensitivity levels.
Details the types of tubes and fuse specifications.
Lists amp's power draw and physical size.
Provides weight and speaker details for combo version.
Advice on protecting tubes from stress and cooling the amp.
Guidance on using standby, avoiding dust, and cleaning.
Ensuring adequate air, load, and operating within temperature limits.
Recommendations for replacing tubes and bias adjustment.
Checks for power issues when the amp doesn't turn on.
Troubleshooting issues with footswitch or MIDI switcher response.
Diagnosing and resolving issues with no sound from the speaker.
Identifying and fixing sources of humming or noise.
Using a dual footswitch for amp functions.
Using a MIDI switcher for flexible remote control.
Details on footswitch jack pin assignments.
To Next Page
