Need help?Do you have a question about the Engl Powerball-2 and is the answer not in the manual?
General| Power Output | 100 Watts |
|---|---|
| Reverb | No |
| Tubes (Preamp) | 4 x ECC83 / 12AX7 |
| Tubes (Poweramp) | 4 x 6L6GC |
| MIDI | Yes |
| Impedance | 4, 8, 16 Ohms |
| Speaker Outputs | 2 x 4 Ohms, 2 x 8 Ohms, 1 x 16 Ohms |
| EQ | 3-band EQ per channel |
| Effects Loop | Yes |
| Channels | 4 (Clean, Crunch, Lead 1, Lead 2) |
| Dimensions | 71 x 27 x 29 cm |
Describes the input jack and gain controls for all four channels of the amplifier.
Details EQ, voicing, and tone shaping controls across all channels, including Bright, Bottom, and Middle-boosted features.
Covers volume levels for each channel and methods for channel selection and switching.
Details master volume selection, power tube monitoring, standby mode, and main power controls.
Explains the Noise Gate threshold setting for suppressing noise in lead channels.
Information on the power input connector and fuse replacement procedures.
Details the connection for the ENGL Z-9 Custom Footswitch for remote amp control.
Details connections for conventional footswitches like Z-4 and MIDI switchers.
Explains the FX Loop send, return, and balance controls for external effects.
Specifies the speaker output impedance options (4, 8, and 16 Ohms).
Troubleshoots problems related to remote control via footswitches and system response issues.
Diagnoses and resolves issues where no sound is produced by the speaker.
Addresses causes and solutions for humming or unwanted noise from the speaker.
Explains troubleshooting for the electronic power amp protection circuit and potential causes.
Details output power ratings and input sensitivity levels for various modes.
Lists power consumption figures and required fuse types and ratings.
Identifies the types and grades of tubes used in the amplifier.
Outlines the processor, software, and proprietary data protocol.
Provides the physical size and weight of the amplifier head.
Diagram showing tube placement and their specific roles in the amp circuitry.
A section to record tube replacements, dates, and reasons.
Details the specialized Z-9 footswitch and its connection via the S.A.C. Port.
Explains using Z-4 or MIDI switchers with other jacks for remote control.
Provides wiring details for footswitch jacks and the S.A.C. port.
To Next Page
