MICROMOTOR MAINTENANCE
The Micromotor is capable of speeds up to 35,000 RPM for use in cutting, sectioning and drilling. It contains
sealed bearings and does not require any lubrication. The Micromotor has cooling vents at the back of the
unit, Do not allow water, oil, or any other substance to enter these vents. Failure to keep debris out of the
micromotor will shorten the life of the unit and cause permanent damage.
IMPORTANT:
1. NEVER change the direction of the Micromotor while it is in operation. ALWAYS wait until it has come to a
full stop.
2. NEVER allow oil or any liquid to get into the Micromotor.
10
To Next Page
Loading...