Assemble vehicle
7
Step 4:
Use the designated tool totighten the
screws,headlight and front fender as
shown.Secure them onto thefront fork,
and check the stability of the connection
between the front lightand Fender with
the front fork.
Step 5:
Use the designated tool to tighten the
screws shown in thepicture,secure it on
thefront fork,and check the stability of
the connection between the fender and
the front fork.
Step 6:
Using the designated tool,remove the
Shipping Axle,and securethe front
wheel in the position shown in the
diagram.Ensure that the disc brake and
brake areon the same side.Use the
specified toolto tighten the screws as
shown in the diagram and check the
stability of the connection between the
front wheel and the front fork.
To Next Page
Loading...