12
4.3 Button definitions
There are five buttons on the operating unit of display YL80C, i.e., the on/off
button , plus button , minus button , headlight button and
switching button .
5. General operation
5.1 Power on/off
By pressing and holding the button , the display will start to work and the
working power supply of the controller will be turned on. In the power-on state,
by pressing the button , your e-bike will be powered off. In the power-off
state, the display will no longer use the battery power, and its leakage current
will be less than 1uA.
■ If your e-bike is not used for more than 10 minutes, the display will be
automatically powered off.
5.2 Display interface
After the display is turned on, the display will show the real-time speed (km/h)
and the trip distance (km) by default. By pressing the button , the
information displayed will be switched between the trip distance (km), ODO
(km), maximum speed (km/h), average speed (km/h) and riding power.
5.3 Push assistance
By pressing and holding the button , the electric push assistance mode
will be enabled. Your e-bike will run at the constant speed of 6km/h. The
display will show . By releasing the button , your e-bike will
immediately stop power output and return to the state before push assistance.
■ The push assistance function can only be used when you are pushing your
e-bike. Please do not use it during riding.
To Next Page
Loading...
