13
5.4 Headlight on/off
By pressing the button , the controller will turn on the headlights and the
display backlight will turn dark; by pressing the button again, the
controller will turn off the headlights and the display backlight will resumes the
luminance.
5.5 Assist level selection
By pressing the button / , the e-bike assist level will be switched to
change the motor output power.
5.6 Battery level indicator
The battery level indicator consists of five segments. When the battery is fully
charged, the five segments will be all on. In case of undervoltage, the outline
of the battery indicator will flash, which means the battery has to be charged
immediately.
5.7 Error code indicator
When a fault occurs in the electronic control system of your e-bike, the display
will automatically indicate the error code. Detailed definitions of error codes
are shown in Schedule 1.
■ When an error code appears on the display interface, please conduct
troubleshooting in time. Otherwise, your e-bike will not work normally.
6.General setting
■ All parameters can only be set when your e-bike stops.
The steps for general setting are as follows:
In the power-on state, when the display shows the speed of 0,
(1) Press and hold the buttons and at the same time for more than
2 seconds to enter the selection interface of general setting options;
(2) Press the button / to switch the selection interface of general
To Next Page
Loading...
