EasyManua.ls Logo

Enhance Mobility MOJO Auto-Fold - Page 10

Enhance Mobility MOJO Auto-Fold
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Clot
h
cove
Remote
Relay
Box
To unfold (open) the MOJO Scooter, press and hold the open button on the key fob until the scooter is fully
open.
To Fold (close) the MOJO Scooter press and hold the fold button on the key fob until the scooter is fully
closed.
The Telescoping Tiller can be raised or lowered before or after folding or unfolding the scooter.
Press the Power Button to turn on and off the scooter.
Press the Headlight Button to turn on and off the headlights.
The remote indicator light comes on when a button is pressed on the remote control. If you press a button and it
flickers or does not come on, the battery in the remote control should be replaced. The remote control uses a
CR3032 battery. If the remote indicator light doesn’t turn off, it indicates one of the buttons is stuck on the
remote control and needs adjustment.
Syncing the Remote Control (Key Fob)
Find the Remote Relay Box by lifting the cloth along the bottom of the scooter, located directly below the seat.
Press the button on the remote relay box one time. The blue light will flash three times and you will hear three
beeps. Then press the close button once with the remote control. The blue light will flash three times and there
will be two beeps indicating the remote has been successfully synced.
To clear the remote-control memory, press and hold the button on the remote relay box for five seconds. There
will be one beep to indicate the memory has been cleared.