Lift armrest,
adjust bolt
here
Battery is not charging
Check that the cord is plugged into the wall and scooter completely.
If there is no light lit on the charger box when plugged into the wall, the charger may be broken. Call for
service.
Lost keys or remote control
Call your local MOJO dealer to order replacements
Armrests not staying up
Use 4mm Allen wrench to adjust bolt on armrest and a 10mm nut is used to hold the bolt in place. First
loosen the nut. If you tighten the bolt, the pitch of the arm rest will go down. If you loosen the bolt, the
pitch of the armrest will go up. Tighten the nut to lock the pitch intoplace.
MOJO Error Indicators
If your MOJO won’t go, listen to the beeps to help trouble shoot the cause.
The Battery needs to be charged or there is a bad connection. Check the battery connections,
if the battery connections are good, charge the battery.
There is a bad connection to the motor. Check all connection between the motor and the
controller.
The motor has a short circuit of a battery connection. Contact your service agent.
The S-Drive cannot be driven which may be because the battery charger is connected. Check
to make sure the battery charger is not connected.
The throttle is out of order. Make sure no pressure is on the directional control levers and the
levers are in the parking position before switching on scooter power.
A controller fault is indicated. Make sure all connections are secure.
The parking brake has a bad connection. Check the free-wheel lever isdisengaged. Check
the parking brake and motor connection. Make sure the controller connections are secure.
An excessive voltage has been applied to the controller. This is usually due to a battery
connection problem. Check battery connection.
If you continue to have trouble with your MOJO, contact Enhance Mobility at 800-296-4151 – Option 2 or your
authorized MOJO dealer.
To Next Page
Loading...